GET THE BEST PERFORMANCE FROM YOUR PRODUCTS.
PRODUCT AFTER CARE HUB

Never leave a candle burning unattended.

Burn candles out of reach of children and pets.

Always leave at least 10cm between burning candles.

Only burn tin candles on a level, heat-resistant surface.

Burn tin candles for a minimum of 3 hours to ensure an even melt pool. For large tins, burn for 4 hours. This will stop your candle from tunnelling, which will leave a perimeter of un-melted wax around your tin. If you find you have a tunnelling issue, try heating up the tin with hot air (such as a hairdryer) to evenly disperse the wax. Note, this is only effective if the tunnelling is not too deep.

Trim your wicks to 5mm before each burn for best scent release.

Extinguish when 5mm of wax remains in the candle tin.

If possible, snuff the flame rather than blowing it out.

Place melts in a clean and empty oil burner or electric warmer bowl.

Do not add any water or oil and use unscented tealights.

When the fragrance is spent, allow wax to cool and harden, remove from the bowl and dispose with household waste.

Do not wash or dispose spent wax down the drain!

You can light a tea light and after a few seconds it will warm the bottom of the wax enough to push out of the oil bowl and then wipe clean.

You can use a blunt instrument to gently persuade the wax from the burner.

If you want to crack on with your next melt, but your wax is still in liquid form, use a cotton ball to soak it up and empty the bowl.

Each time before burning this candle, ensure the wick is trimmed to 1.5cm.

It is possible that the candle wax will burn at a different rate to the candle art design. If this happens you must trim any excess height so that the design does not tower over the flame.

Do not burn this candle underneath any object that is loose or flammable.

Do not leave this candle burning unattended.

It is possible that pillar candles can drip wax, therefore it is recommended that you burn this candle inside a pillar candle glass, or on a hard, heat-proof surface.